5 Easy Steps to Make a Bottle Holder From a Single Piece of String

This brief tutorial is based on my recent wanderings around the hills of Northern Italy.  It was dusk as I began my several hour walk and about half-way to my destination a cloud rolled in, covering the path and helping me to get lost for an extra hour.  Luckily, I had a nice chilled bottle of white wine to refresh my body and spirits.

While wandering these paths, I realize that I could do with a nice wine pouch or sling, so that I did not need to keep putting the bottle in and out of my backpack.  Finding a nice strong length of string (about three feet long), I worked out a way to create a simple wine sling to serve me for the day. The following five steps are a quick “How To.”

(1)Have a bottle of wine / be on a mountain path

(2) Take a length of string, approximately three feet long.  Near the middle of the string, tie two slip knots into the string about 3 centimeters apart from each other.  Ensure that you tie the knots so that each one can be tightened by pulling on the string end leading away from it — this is important because it means that tension in the string makes it grip the bottle more tightly.

(3) Tie a square knot to link the two free ends of the string together.

(4) Loop each slip knot over the top of the bottle (below the upper lip) and tighten.

(5) Sling the string over your shoulder or neck and get hiking. Stop for a gulp as needed.

Leave a Reply

Your email address will not be published. Required fields are marked *